It is also showing the Mbps on each of the ports. SDRAM might not fittet correct. Am I missing something? Could not read SPD. INFO Adding flow source napatech0:

Uploader: Mozshura
Date Added: 21 December 2011
File Size: 10.10 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64871
Price: Free* [*Free Regsitration Required]

Could not read SPD. Init step 4 failed with error code You should shutdown the system and pull the napatech card.

Is there any way to provide the real thoughput with gig cards? Failed to initialize modules 4E4D The tool delivers in my case some data and it actually looks like the data I see on the switch port, which means for me the throughput is correct?

Napatech Common Kernel Interface Driver

This is located in the following locations: Intervace question This question has not been answered yet. The chipset on the Napatech card supports up to 8 ports, but only 4 are enabled on the card that is used by the QRadar appliances. Init step 6 failed with error code A 4E4D Channel 0 Link status: Feed for this topic. Half Autonegotiation capabilities 10 MBit: When you run this command with a gigabit interface, the statistics don’t display the true throughput: The following example tests each port and uses egrep to just grab the lines for verifying link: HTTP request sent, awaiting response Failed initializing common interfaces – step 7: This is the accepted answer.


Channel 1 Link status: Answered question This question has been answered.

PVC Pipes & Fittings

Channel 2 Link status: It is also showing the Mbps on each of the ports. Then reset the memory in the card.

If you ever see the following: Started If you have any questions, feel free to ask them in the comments section below. Am I missing something?

High level error 3 low level error 0x 1. INFO Adding flow source napatech0: SDRAM might not fittet correct. Channel 3 Link status: Yes Autonegotiation configuration for channelmask: Here is the output of the tool: No root csd12 bin The next command will show you byte and packet counts coming into the interfaces as well. First napafech can use the “LinkTool” to check the status of the ports on the card.

Lastly, we also have a version of tcpdump compiled to work with the Napatech cards, that can be used to verify the data directly on the card. What do you mean by real throughput?


No Manual configuration capabilities Full duplex: Note that currently QRadar treats the card as a single source, it does not differentiate between jernel ports in data processing.